Legs
Have a bed by koala fits perfectly.
Light weight strong aluminium bedchair support leg, designed to fit all makes of bedchair ensuring end support to allow extra weight on otherwise unsupported areas of your bedchair. The clamp on design uses a thumbscrew and nut system which when fitted can be left on your bed-chair as picture no.3 shows clearly.
Fully height adjustable using push level clips to allow fitting at either end of your bed whilst the addition of mud feet keep a firm footing on any surface.
The leg support clamp measures 22mm internally when in the closed position and is best suited to this size - you can however use the item on beds & bedchairs with frames smaller than 20mm - just bear in mind that the clamp will not grip onto your frame.
Dimensions: Adjusts in height from 30-43cm.
Width: 30cm
Have a bed by koala fits perfectly.
A bit of a fiddle to get it in place but once it was on no problems
I have a fox 2 legged bed chair about 3 years old,and its always tipping up when a get out at night when my bite alarm screams off,and I'm getting p......d off with it . Can't afford a new one or am a to tight?.so when I saw these on the koala web site I bought 2 one for each end.when they arrived I thought they were well made and I was pleased with them.they were hard to fit to my bed chair as the ends of the chair is sort of round ( semi circle)but I managed to fit them with a bit of twisting ect.And they do the job as intended.
